![IMG_9556[1].PNG](https://static.wixstatic.com/media/8549fe_cc4ed726737746779b5dd1f98be937b6~mv2.png/v1/fill/w_12,h_7,al_c,q_85,usm_0.66_1.00_0.01,blur_2,enc_avif,quality_auto/8549fe_cc4ed726737746779b5dd1f98be937b6~mv2.png)
Welcome to the install page and general Questions page!
Follow the instructions below, installing your battery or cutting your panel harness other than instructed voids warranty.
Black BOX INSTALL
First off install your black box.
1. Lay your shuttle down with the front panel facing down.
2. Remove the (4) 3/4" stainless bolts from the backwall.
3. lay your black box down over the pretapped bolt holes
4. Using a phillips screwdriver or power drill - stick bolts into the pretapped holes and slowly tighten until snug.
Your black box is now installed! How simple.... :)
ELECTRICAL Connections
Electrical isnt complicated. The way we have laid out the electrical makes things simple and easy to understand.
For Garmin users - Follow this diagram to see the wires needed. We do not supply 221 Wago's for stock power supplies - Garmin's 4 in 1 harness is required.
MANUAL HARNESS' OTHER THAN GARMIN 4 in 1 - FOLLOW THIS-
Simply get 221 3 Spot Wago's to connect your extra wires from black box and garmin head unit. by simply cutting and stripping suppplied ends of your panel harness labeled "Sonar + and Sonar -, then push into 1 wago spot, then proceed to push in and close the corresponding power wires into the remaining 2 locations for your wago. Do the same for your negative wires.
Lowrance can also use this diagram to connect and hookup your head units.
For Guys who selected Mega Live 1-2 on checkout, you will need to buy "221" 3 Spot Wago's to connect your extra wires for your dual power wire, negative wires and shielding wire. Please note we do not supply any extra fuses or wagos and are your responsibility to have if your unit requires them. See MANUAL HARNESS' OTHER THAN GARMIN 4 in 1 - FOLLOW THIS- Section for wiring.
((Again -Your harness will come with 1 Sonar + and 1 Sonar - Connection))
Because lever wago's are used we strongly recommend electrical taping over them after install so no levers pop loose from travel or moving around inside the shuttle. We tape EVERY wago so you see how this is done and make sure you have no loose ends when your shuttle arrives. If you have any questions, John is a call away and can walk you thru any step you need!! 507-313-1601
Follow these directions for properly installing GX Shuttle mount kit and Linq System to your shuttle.
Please note modifying or changing mounts, brackets, hole locations or adding extra hardware voids your warranty and you assume all responsibility for installing against our recommendations on what is safe and recommended.